3 The MiniDriver Data Dialog Box

The following error messages are associated with the MiniDriver Data dialog
box.

List                              Description
---------------------------------------------------------------------------

Illegal GPC Major Version         UniTool issues this message if the value
Number, must be 0<=n<=1           specified in the Major box is not 0 or 1.

Illegal GPC Minor Version         UniTool issues this message if the value
Number, must be 0<=n<=255         specified in the Minor box is outside of
                                  the specified range (0 - 255).

Structure-Name Conversion error   UniTool issues this message whenever the
                                  new master units result in a round-off
                                  error after they are divided into a
                                  specified member in the MODELDATA,
                                  RESOLUTION, PAPER-SIZE, PAPER-SOURCE,
                                  CURSOR-MOVEMENT, or RECTANGLE-FILL data
                                  structures. For example, if the
                                  sLeftMargin box of the ModelData dialog
                                  box contains the value 179, and the
                                  horizontal master unit was changed from
                                  360 to 180, the conversion error message
                                  would appear because 89.5/180 cannot be
                                  expressed as an integer value. UniTool
                                  also replaces the data structure
                                  identified by Structure-Name with the
                                  appropriate string.