1 Validate Dialog Boxes

The Validate Dialog Boxes command may be chosen or canceled at the
discretion of the UniTool user. When it is chosen, whenever you display a
dialog box and choose OK, Next, or Previous (that is, any choice that will
cause the current dialog box contents to be saved rather than ignored),
UniTool will perform some limited error checking on the contents of that
dialog box. If any potential problems are found, a new dialog box listing
all the potential problems will be displayed, and you may choose to ignore
these warnings or return to the dialog box to correct them. All of the
error messages, along with a corresponding explanation, are listed at the
end of this appendix. If the Validate Dialog Boxes command is not chosen,
error checking will not occur. This command is enabled by default.