MCI_FREEZE

Freezes motion on the display. This command is part of the video overlay command set. The parameters and flags for this message vary according to the selected device.

DWORD lParam1
The following flags apply to all devices supporting MCI_FREEZE:
MCI_NOTIFY Specifies that MCI should post the MM_MCINOTIFY message when this command completes. The window to receive this message is specified in the dwCallback member of the structure identified by lpFreeze.
MCI_WAIT Specifies that the freeze operation should finish before MCI returns control to the application.
MCI_OVLY_RECT Specifies that the rc member of the structure identified by lpFreeze contains a valid rectangle. If this flag is not specified, the device driver will freeze the entire frame.

LPMCI_OVLY_RECT_PARMS lParam2
Specifies a far pointer to a MCI_OVLY_RECT_PARMS structure. (Devices with additional parameters might replace this structure with a device-specific structure.)

See Also

MCI_UNFREEZE